Go to footer

Can Unoas share face plates?

MSD, Tonners, or 40cm + (18" range)

Can Unoas share face plates?

Postby DollyKim » Sun May 18, 2025 8:55 am

It was asked on DOA if Lusis and Chibi unoas can share face plates, might as well put it here to.
Basic answer is no.

Image

Image

Lusis in green with a yawn plate, chibi in paw prints with one of the defaults, the size is the same but the way of keeping the face on is way different. It could be done with tape or some other modding but you'd essentially be limited to just one face because swapping would be a pain.
User avatar
DollyKim
Dr. Dollittle
 
Posts: 7919
Joined: Sat Mar 20, 2010 3:07 pm
Location: At the base of Mt Baldy


Re: Can Unoas share face plates?

Postby happyknot » Fri Jun 13, 2025 4:01 pm

This is good to know. I wonder why they are made this way.
User avatar
happyknot
Dolly Pardon
 
Posts: 283
Joined: Sat Dec 03, 2011 1:35 am
Location: Canada


Return to Board index

Return to 1/4 Scale

Who is online

Users browsing this forum: No registered users and 1 guest